Tag: ago control

Building a battery powered WiFi IoT Sensor with ESP8266, MS-5611 (GY-63), nodemcu and MQTT

Introduction The ESP8266 is a 32 bit micro controller with an integrated WiFi chipset and TCP/IP stack. The flash is connected via SPI. Firmware upgrades can be done via the serial port after booting with GPIO0 pulled to ground (I’m

Posted in ago control, DIY, Supported Hardware Tagged with: , , , , , ,

RaZberry Pi Z-Wave module arrived

The brand new RaZberry did arrive last week. It works like a charm with ago control. Just make sure to use “/dev/ttyAMA0” as device in the “zwave” config section. Kudos to the folks from Z-Wave.Me for this very nice piece

Posted in ago control, raspberry pi, Supported Hardware Tagged with: , , ,

rain8net device support added

We’ve added rain8net device support for the commonly used units from WGL Design: http://www.wgldesigns.com/rain8pc.html More information is provided in the forum thread: http://www.agocontrol.com/forum/general-discussion/rain8net-support-added/

Posted in ago control, Supported Hardware Tagged with: , , , ,

Remote control APC Switched Rack PDU

ago control now supports the APC Switched Rack PDU and you now can switch on or off power outlets of the PDU. You ever had a problem with an air condition failure and wanted to switch on extra fan units

Posted in ago control, Supported Hardware Tagged with: , ,

Asterisk PBX Support

You now can remote control a Asterisk PBX with ago control. We just released a interface device for Asterisk PBX support. It communicates via the AMI (Asterisk Management Interface) and supports the “dial” command and announces SIP phones as “phone”

Posted in ago control Tagged with: , , ,

Enhanced KNX experience

The KNX driver is now packaged to give better user experience. No need to compile the agoknx daemon yourself anymore. We also provide bcusdk/eibd debian packages for armel, armhf, i386 and amd64 on our mirror. That makes it very easy

Posted in ago control Tagged with: , , , , , , ,

Aeon Labs Z-Stick with a Raspberry Pi

A picture of the ago control Raspberry Pi Z-Wave test setup: Runs for some weeks now, no issues.

Posted in ago control, raspberry pi, Supported Hardware Tagged with: , , ,

Raspberry Pi packages available

Current packages for the Raspberrry Pi can be found on our mirror. You can install them via apt-get. Add the following to the sources list: deb http://mirror.at.agocontrol.com/debian wheezy main Next run an “apt-get update” and “apt-get install agocontrol agocontrol-admin“. Please

Posted in ago control Tagged with: , , , ,