I am just wondering after installing some updates on the website, that the last news was posted at 2015 – perhaps we should not just communicate in IRC 😉 Status – working since years. Perhaps ago control is a no-dead-end…
Category: ago control
Building a battery powered WiFi IoT Sensor with ESP8266, MS-5611 (GY-63), nodemcu and MQTT
Introduction The ESP8266 is a 32 bit micro controller with an integrated WiFi chipset and TCP/IP stack. The flash is connected via SPI. Firmware upgrades can be done via the serial port after booting with GPIO0 pulled to ground (I’m…
Posted in ago control, DIY, Supported Hardware Tagged with: ago control, battery, ESP8266, IoT, MQTT, nodemcu, WiFi
Release 1.0 pending
We’ve released a 1.0 candidate on our “testing” repository. Please help with testing. If we don’t find any showstoppers, this will become 1.0 in a few weeks.
Posted in ago control
ImperiHome support
We’re in the process of adding support for the ImperiHome Android app. The basic things are working already. A package is available (agocontrol-imperihome). Stay tuned for more news about the progress.
Posted in ago control
MySensors support
We’ve added MySensors support. Visit http://www.mysensors.org for details on how to build your own sensors with arduino and NRF24 RF modules.
ago control 1300+ commits
It’s time to say thank you to all ago control developers. Now there 1308 commits, super slim core with 5621 lines of code, 40+ devices supported. All core is now written in C++. The Web Admin is working so far and the basic Android App features are…
Massive CORE changes
Hello folks, we’re making big changes to the codebase. If you rely on a stable system, I’d suggest to not update over the next 4 weeks. We’ll push in a lot of improvements at core parts and as well into…
Very bad experience with Linux on VIA APC Rock
We were searching for Raspberry Pi alternatives. The Cortex A9 seems to be a good choice. Besides more speed it is able to run stock Debian Wheezy. (Raspberry Pi needs ARM6 binaries, so you need to run Raspbian). We did find…
Big CORE changes
We did a few major upgrades the last days. The biggest change is the move to the new resolver which was completely rewritten in C++ and a major change in Z-Wave device. Switching the resolver from python to c++ The…
RaZberry Pi Z-Wave module arrived
The brand new RaZberry did arrive last week. It works like a charm with ago control. Just make sure to use “/dev/ttyAMA0” as device in the “zwave” config section. Kudos to the folks from Z-Wave.Me for this very nice piece…
Posted in ago control, raspberry pi, Supported Hardware Tagged with: ago control, home automation, raspberry pi, z-wave
Recent Comments