Category: raspberry pi

RaZberry Pi Z-Wave module arrived

The brand new RaZberry did arrive last week. It works like a charm with ago control. Just make sure to use “/dev/ttyAMA0” as device in the “zwave” config section. Kudos to the folks from Z-Wave.Me for this very nice piece

Posted in ago control, raspberry pi, Supported Hardware Tagged with: , , ,

Raspberry Pi GPIO support

Thanks to apagg there is a Raspberry Pi GPIO device interface available: http://www.agocontrol.com/trac/browser/agocontrol/agocontrol/devices/raspiGPIO/raspiGPIO.py That makes it very easy and cheap to start with home automation. Just attach relays and binary sensors to the GPIO ports of the Raspberry Pi and configure

Posted in ago control, raspberry pi, Supported Hardware Tagged with: , ,

BlinkM RGB LED on Raspberry Pi

ago control now supports BlinkM RGB LED and how to wire and install it on a Raspberry Pi. The BlinkM is controlled via the I2C Bus which is available by default in the Raspberry Pi; you just need to enable it.

Posted in ago control, raspberry pi, Supported Hardware Tagged with: , ,

RaZberry Raspberry Pi Z-Wave add on module

We’ll receive samples of the RaZberry Z-Wave add on for the Raspberry Pi soon. So you can expect them to work flawlessly with ago control. You can find more information regarding the module here: http://razberry.zwave.me

Posted in ago control, raspberry pi, Supported Hardware Tagged with: , ,

Aeon Labs Z-Stick with a Raspberry Pi

A picture of the ago control Raspberry Pi Z-Wave test setup: Runs for some weeks now, no issues.

Posted in ago control, raspberry pi, Supported Hardware Tagged with: , , ,